[Prism54-users] cell 00

[Istvan Turk]

i have same distro, same card and same problem with the latest driver!
i can't find any solution yet :(

but 20031128 snapshot with 2.6-test11 kernel works for me!

cheers,
mosquito

Johannes Zellner wrote:
> Hi,
> 
> with kernel 2.6.0-test11 and the latest prism54 from CVS I can bring up
> my SMC2802, but it shows
> 
>     # iwconfig eth2
>     eth2      PRISM Duette/GT  ESSID:"my essid"  
>               Mode:Ad-Hoc  Channel:6  Cell: 00:00:00:00:00:00  
>               Sensitivity=0  
>               Retry min limit:0   RTS thr=0 B   Fragment thr=0 B   
>               Encryption key:FFFF-FFFF-FFFF-FFFF-FFFF-FFFF-FF   Security mode:restricted
>               Link Quality:0  Signal level:0  Noise level:0
>               Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>               Tx excessive retries:0  Invalid misc:0   Missed beacon:0
> 
> so it seems that Cell == 00.. is wrong. I'm running debian unstable with
> the appropriate packages (hotplug / iwconfig) installed. The card worked
> with 2.6.0-test10 and the prism54 driver of about 2 - 3 weeks ago. After
> bringing up the driver, dmesg shows:
> 
>     # dmesg
>     Loaded prism54 driver, version 1.0.2.2
>     eth2: uploading firmware...
>     eth2: firmware uploaded done, now triggering reset...
>     eth2: prism54_mib_init()
>     eth2: islpci_open()
>     eth2: resetting device...
>     eth2: uploading firmware...
> 
> for completeness, here is what lspci shows:
> 
>     # lspci -vv
>     00:09.0 Network controller: Harris Semiconductor D-Links DWL-g650 A1 (rev 01)
>             Subsystem: Standard Microsystems Corp [SMC]: Unknown device 2802
>             Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
>             Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
>             Latency: 80 (2500ns min, 7000ns max), Cache Line Size: 0x08 (32 bytes)
>             Interrupt: pin A routed to IRQ 5
>             Region 0: Memory at e2000000 (32-bit, non-prefetchable) [size=8K]
>             Capabilities: [dc] Power Management version 1
>                     Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
>                     Status: D0 PME-Enable- DSel=0 DScale=0 PME-
> 
> I've ACPI turned OFF!
> Would be nice, if I could get the card functional again ;-)
>