[Prism54-devel] Problems to connect to ALLNET 0172
Karsten Rose
rosek.news@arcor.de
Sun, 08 Feb 2004 00:08:25 +0100
Hello,
after checking the IRC I was send to this list.
I'm trying to get a Allnet 0172 working as an AP with limited success so
far. I'm using the fli4l
package Debian based as far as I know Ver. 2.1.5
I'm using the current firmware 1.0.4.3 and the current prism54 driver
1.0.2.2
The result of iwconfig and ifconfig looks normal to me but other cards
can not connect, I have as
you can see no security enabled for the start, so this should not disturb.
But I do notice a completely different output from the firmware on my
machine compared to what others
show e.g. in the bugzilla cases (#54?)
Is there a documentation somewhae of what should be stated or of what
are the possible commands.
Who can give me a hint?
fli4l 2.1.5 # ifconfig eth2 up
remove_proc_entry: 00:0a.0/loading busy, count=1
remove_proc_entry: firmware/00:0a.0 busy, count=1
de_put: deferred delete of loading
de_put: deferred delete of 00:0a.0
fli4l 2.1.5 #
fli4l 2.1.5 # iwconfig eth2
eth2 IEEE 802.11b/g ESSID:"fli4l"
Mode:Master Channel:1 Access Point: 02:10:91:96:67:F2
Bit Rate:54Mb/s Tx-Power=31 dBm Sensitivity=20/200
Retry min limit:8 RTS thr:2347 B Fragment thr:2346 B
Encryption key:1A43-CD39-F037-77AC-31FF-F983-D3 Security
mode:open
Link Quality:240 Signal level:0 Noise level:16
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
fli4l 2.1.5 #
fli4l 2.1.5 # ifconfig eth2
eth2 Link encap:Ethernet HWaddr 02:10:91:96:67:F2
inet addr:192.168.7.1 Bcast:192.168.7.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:12
fli4l 2.1.5 #
Thanks for your help
Karsten