[Prism54-users] Netgear WG311 Installation

[m0bius]

> -----Original Message-----
> From: prism54-users-admin@prism54.org [mailto:prism54-users-
> admin@prism54.org] On Behalf Of kaleda
> Sent: Thursday, January 22, 2004 11:50 AM
> To: prism54-users@prism54.org
> Subject: RE: [Prism54-users] Netgear WG311 Installation
> 
> > This I don't know, but when I run iwconfig I get "no wireless
> extensions"
> >
> > wlan0     Link encap:Ethernet  HWaddr 00:09:5B:2F:75:A7
> >           BROADCAST MULTICAST  MTU:1500  Metric:1
> >           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> >           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> >           collisions:0 txqueuelen:1000
> >           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
> >           Interrupt:12 Memory:c48fd000-c48fe000
> >
> > This is my prism 2.5 netgear 802.11b pci card (not the WG311)
> 
> possible problem:
> Have you enabled these *BOTH* in your kernel:
>           CONFIG_NET_RADIO=y
>           CONFIG_NET_WIRELESS=y
> 
> try doing cat /proc/net/wireless
> If no such file - you'll have to enable those tags & recompile kernel.
> 

Yeap both of the are enabled. And cat /proc/net/wireless returns
information.

Regarding to the mail from Alexandros Vavoussis, I've done everything
exactly you said.

Unfortunately Max did send me his patch for this firmware issue but it came
corrupted and I'm waiting for him to resend it...

I can't seem to figure out what is going on...

Shouldn't by setting #define VERBOSE 0xFF get all the information from the
module cause I'm not getting anything back...

Paris