[Prism54-users] Netgear WG511, Kernel 2.4.23 TRAP

[Karl-Heinz Herrmann]

On Sat, 17 Jan 2004 17:56:58 +0100
Rene van Bevern <rvb@rvb.dyndns.org> wrote:
> Well, the problem is that it does not find the access point, instead
> instead i get a lot of TRAPs ... Here is an excerpt from the syslog
> after inserting the card and trying to bring up an interface:
> (using ifconfig and iwconfig)
> 
> Jan 17 17:24:55 schrebbel kernel: PCI: Enabling device 05:00.0 (0000
> -> 0002) Jan 17 17:25:04 schrebbel kernel: eth0: islpci_open()
> Jan 17 17:25:04 schrebbel kernel: eth0: resetting device...
> Jan 17 17:25:04 schrebbel kernel: eth0: uploading firmware...
> Jan 17 17:25:04 schrebbel kernel: eth0: firmware uploaded done, now
> triggering reset... Jan 17 17:25:04 schrebbel kernel: eth0:
> prism54_mib_init() Jan 17 17:25:04 schrebbel kernel: eth0: done with
> prism54_mib_init()! -- Client Managed mode Jan 17 17:25:06 schrebbel
> kernel: TRAP: oid 0x18000001, device 3, flags 0x0 length 12 Jan 17
> 17:25:24 schrebbel last message repeated 4 times Jan 17 17:25:25
> schrebbel kernel: TRAP: oid 0x18000003, device 3, flags 0x0 length 12
> Jan 17 17:25:27 schrebbel kernel: TRAP: oid 0x18000001, device 3,
> flags 0x0 length 12[...]


Well.... I get exactly the same TRAP oid lines on a successful connect.

I do get one different looking one:
Jan 17 18:12:26 khhlap kernel: TRAP: oid 0x1, device 5, flags 0x0 length
4

What makes you sure it does *not* work? iwconfig output? LED's? pinging?
Did you set the SSID correctly, WEP,...?


K.-H.