[Prism54-users] Can't make a SMC2802W work. Maybe it's my hardware setup? Doing something wrong?

[bapm]

Hi.
=20
I just tryied the latest CVS version from today and I can't make my =
SMC2802W PCI work in my linux box.
=20
I'm using kernel 2.4.24 with the CVS patch from today. I didn't forget =
to have modules for prism and hot plug firmware. I also installed the =
hotplug firmware agent. Firmware is the latest available on prism54.org =
(1.0.4.3).
After doing a modprobe prism54 I get this dmesg:
=20
  Loaded prism54 driver, version 1.0.2.2
  divert: allocating divert_blk for eth3
  eth3: islpci_open()
  eth3: resetting device...
  eth3: uploading firmware...
  remove_proc_entry: 00:09.0/loading busy, count=3D1
  remove_proc_entry: firmware/00:09.0 busy, count=3D1
  eth3: firmware uploaded done, now triggering reset...
  de_put: deferred delete of loading
  de_put: deferred delete of 00:09.0
  eth3: device soft reset timed out

Check iwconfig output:
=20
  eth3      NOT READY!  ESSID:""
            Mode:Managed  Channel:6  Access Point: 00:00:00:00:00:00
            Tx-Power=3D0 dBm   Sensitivity=3D0/200
            Retry min limit:0   RTS thr=3D0 B   Fragment thr=3D0 B
            Encryption key:off
            Link Quality:0  Signal level:0  Noise level:0
            Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
            Tx excessive retries:0  Invalid misc:0   Missed beacon:0

Trying another reset with iwpriv also doesn't work. Using all the =
available firmwares didn't help either.
The card refuses to colaborate. Output of /proc/interrupts after several =
tests. IRQ number doesn't change:
=20
             CPU0
    0:      55476          XT-PIC  timer
    1:          2          XT-PIC  keyboard
    2:          0          XT-PIC  cascade
    8:          1          XT-PIC  rtc
   10:          0          XT-PIC  eth3
   11:         44          XT-PIC  eth2
   12:       2723          XT-PIC  eth0, eth1
   14:       7473          XT-PIC  ide0
   15:         64          XT-PIC  ide1
  NMI:          0
  ERR:          0

Maybe the problem is my hardware setup? Firmware doesn't load properlly =
for some reason?
=20
Thanks in advance.
=20
Bruno
=20