Fwd: [Prism54-devel] XG-901 troubles after 15 minutes

[Bob Beers]

D^*& gmail reply button!

---------- Forwarded message ----------
From: Bob Beers <bob.beers at gmail.com>
Date: May 5, 2005 5:58 PM
Subject: Re: [Prism54-devel] XG-901 troubles after 15 minutes
To: Eero Volotinen <eero.volotinen at pronics.com>


> Wlan0? Prism54 is ethX, usually?
>
Yes, i cut my wireless teeth on hostap, so i use ifrename
 to make prism54 into wlanX

> Try with acpi=off
>
Isn't this enough?
root at alakazam:/usr/src/linux# grep -i ACPI .config
# Power management options (ACPI, APM)
# ACPI (Advanced Configuration and Power Interface) Support
# CONFIG_ACPI is not set
CONFIG_ACPI_BLACKLIST_YEAR=0

But I do want to correct something I said in first post:  the card I'm
 getting this behavior from is the miniPCI ZCom XG-601 with this lspci:

bash-3.00# lspci -s 00:0f -vv
00:0f.0 Class 0280: 1260:3890 (rev 01)
        Subsystem: 17cf:0014
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop-
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 64 (2500ns min, 7000ns max), cache line size 08
        Interrupt: pin A routed to IRQ 11
        Region 0: Memory at 80100000 (32-bit, non-prefetchable) [size=8K]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

I do also have the XG-901, and will be testing it soon to see if it
gives the same
 troubles.
--
-Bob