[Prism54-devel] filter or isolation

[Aquila]

Sorry, I’ve been away for a while.
So in case no one else has answered this question (or
else just as a FYI):

You need to set the following OID to zero:
#define DOT11_OID_BRIDGELOCAL           0x15000000

The firmware will then send all traffic between
wireless clients up to the driver. This means that the
bridge on the host (linux system) needs to then bridge
all the traffic between wireless clients. By disabling
this OID you have control over the traffic and you can
route it to wherever you need it.

Regards,
Aquila

-----Original Message-----
From: prism54-devel-admin@prism54.org
[mailto:prism54-devel-admin@prism54.org] On Behalf Of
Webmaster
Sent: Sunday, December 21, 2003 11:08 PM
To: prism54-devel@prism54.org
Subject: [Prism54-devel] filter or isolation
newbie question:
 
urgent: is it possible to modify an access-point
software that ip-traffic from one client to another
client is forbidden?
 
any ideas welcome...
 
u.u.
 


__________________________________
Do you Yahoo!?
Yahoo! Hotjobs: Enter the "Signing Bonus" Sweepstakes
http://hotjobs.sweepstakes.yahoo.com/signingbonus