[Prism54-devel] Enabling WPA on Prism-GT

[Aurelien]

What I mean is that setting the device to use TKIP key, may also make it send automagicaly what you want in the beacon (whithout any explicit attachement).

...And justice for all

On Tue, 30 Dec 2003 14:09:56 -0800
Rafiq Shaikh <rafiq.shaikh@analog.com> wrote:

> Hi Aurelien,
> 
> I did not set the key for this operation.
> I don't think the key is required to send WPA IE inside of Beacon frames.
> My understanding is that once the attachment operation succeeds the new 
> element
> should show up in the outgoing Beacon frames.
> 
> Regards,
> -Rafiq.
> 
> 
> Aurelien wrote:
> 
> >Hi,
> >Did you try to set the type field to DOT11_PRIV_TKIP in the used key ?
> >
> >...And justice for all
> >
> >On Tue, 30 Dec 2003 13:40:37 -0800
> >Rafiq Shaikh <rafiq.shaikh@analog.com> wrote:
> >
> >  
> >
> >>Hi,
> >>
> >>I understand that there is a RID FC28  Flag to enable WPA on  ISL3842 
> >>(802.11b).
> >>Is there a similar OID available to enable WPA on Prism-GT?
> >>
> >>On Prism-GT to enable WPA  I set MLME to EXTENDED, attach WPA IE.
> >>The attachment of WPA IE succeeded but the new element does not show up 
> >>in the
> >>out going Beacons or Probe Responses.
> >>Any suggestions why this is happening?
> >>
> >>Regards,
> >>-Rafiq.
> >>
> >>
> >>_______________________________________________
> >>Prism54-devel mailing list
> >>Prism54-devel@prism54.org
> >>http://prism54.org/mailman/listinfo/prism54-devel
> >>
> >>    
> >>
> >_______________________________________________
> >Prism54-devel mailing list
> >Prism54-devel@prism54.org
> >http://prism54.org/mailman/listinfo/prism54-devel
> >
> >
> >  
> >
>