[Prism54-users] New to the list and a New "Prism" Card

[Maurits Bloos]

Hi All,

Just joined this list...
And was searching to get my PCI card working (Sitecom WL-121v3) under linux.
The manufacturere was helpfull enough to tell me that it has a "Prism" 
Chipset with Nitro MX, i saw some stuff on the list and was wondering if 
there was any good info about how to get this puppy working

If i do a lspci :

00:12.0 Network controller: Unknown device 182d:9790 (rev 01)

and a lspci -vvvv :

00:12.0 Network controller: Unknown device 182d:9790 (rev 01)
        Subsystem: Unknown device 182d:0000
        Control: I/O- Mem- BusMaster- SpecCycle- MemWINV+ VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 0
        Region 0: Memory at f4102000 (32-bit, non-prefetchable) 
[disabled] [size=8K]
        Capabilities: [dc] Power Management version 1
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA 
PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable+ DSel=0 DScale=0 PME-

-- 
With kind regards/Met vriendelijke groeten,

Maurits Bloos

----------------------------------------------------------------------
There are only 10 types of people in the world:
Those who understand binary, .... and those who don't
----------------------------------------------------------------------