[Prism54-users] Netgear WG311 Installation

[Philippe Moutarlier]

Well, I don't known  .. I am just extrapolating ! Netgear calims they
are using only  Atheros and I definitely get Netgear to run using
Prism54. For proof, here is the line I get from dmesg :

eth1: prism54 driver detected card model: Netgear WG511

then later :

eth1: firmware uploaded done .. 

The reset goes OK and I can happily use it ...

go figure ...

Phil


On Fri, 2004-01-30 at 01:58, Luis R. Rodriguez wrote:
> On Fri, Jan 30, 2004 at 01:50:31AM -0500, Philippe Moutarlier wrote:
> > I am using one as we speak !!  Maybe this driver support Atheros after
> > all  ??
> 
> You have an atheros chipset and you are using the prism54 driver and it
> is working?
> 
> 	Luis
> 
> > 
> > 
> > On Fri, 2004-01-30 at 01:21, Luis R. Rodriguez wrote:
> > > On Fri, Jan 30, 2004 at 07:16:52AM +0100, Andreas Pfaffeneder wrote:
> > > > Am Do, den 29.01.2004 schrieb sebastien um 22:09:
> > > > > AFAIK WG311 V1 use Atheros en V2 use Texas, what version
> > > > > is based on prism ?
> > > > 
> > > > I mailed Netgear recently asking what chipset is built into which
> > > > version of the WG311 - the support-guy claimed that all WG311 had
> > > > the Atheros-Chipset (so far).
> > > > 
> > > 
> > > Interesing... who the hell has been submitting successfull reports of
> > > these cards then? Anyone?!
> > > 
> > > Hmm.. 
> > > 
> > > 	Luis
> > > _______________________________________________
> > > Prism54-users mailing list
> > > Prism54-users@prism54.org
> > > http://prism54.org/mailman/listinfo/prism54-users
> > -- 
> > Philippe Moutarlier <philippe.moutarlier@comcast.net>
> > 
> > _______________________________________________
> > Prism54-users mailing list
> > Prism54-users@prism54.org
> > http://prism54.org/mailman/listinfo/prism54-users
> _______________________________________________
> Prism54-users mailing list
> Prism54-users@prism54.org
> http://prism54.org/mailman/listinfo/prism54-users
-- 
Philippe Moutarlier <philippe.moutarlier@comcast.net>