[Prism54-users] New SMC2802W ?

[Louis SWINNEN]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Luis R. Rodriguez wrote:
> first,
>
> ifconfig eth1 up
>
> before anything. Try that after modprobing and just watch the led until it
> starts associating to the AP. Then if you run iwconfig you should see the
> AP's SSID.
>
> 	Luis
>

Done. No LEDs flashs ! The SSID remains empty (iwconfig eth1):

eth1      NOT READY!  ESSID:""
          Mode:Managed  Channel:6  Access Point: 00:00:00:00:00:00
          Tx-Power=0 dBm   Sensitivity=0/0
          Retry min limit:0   RTS thr=0 B   Fragment thr=0 B
          Encryption key:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0


after the 'ifconfig eth1 up' command, dmesg gives the
following messages:
Loaded prism54 driver, version 1.0.2.2
eth1: islpci_open()
eth1: reseting device...
eth1: uploading firmware...
eth1: firmware uploaded done, now triggering reset...

That's all !

Louis.

- --
Louis SWINNEN (http://www.saintlaurent.hemes.be/sites/Sw/).
HEMES Saint-Laurent (http://www.saintlaurent.hemes.be).
This mail is digitally signed using GnuPG (KeyID: 60E91A70).

Thanks to avoid sending me Word or PowerPoint attachments
http://www.fsf.org/philosophy/no-word-attachments.html
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.7 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQFABeOnk3h4FWDpGnARAjbWAKDJdW3mT2Gh67HLvLys0oj1H+vMwgCgo5eU
R6g2t2GnU8ZdP+79u75In4I=
=VU95
-----END PGP SIGNATURE-----