[Prism54-users] (no subject)

[Buffenoir Mathieu]

good evening,

I try to do as you said:

lalu tium # iwconfig 
lo        no wireless extensions.

eth0      no wireless extensions.

eth1      NOT READY!  ESSID:off/any  
          Mode:Managed  Channel:6  Access Point: 00:00:00:00:00:00  
          Tx-Power=31 dBm   Sensitivity=0/200  
          Retry min limit:0   RTS thr=0 B   Fragment thr=0 B   
          Encryption key:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

lalu tium # ifconfig eth1 down
lalu tium # kismet
Server options:  none
Client options:  none
Starting server...
Waiting for server to start before startuing UI...
Will drop privs to tium (1000) gid 100
No specific sources given to be enabled, all will be enabled.
Enabling channel hopping.
Enabling channel splitting.
Source 0 (prism54g_source): Enabling monitor mode for prism54g source
 interface eth0 channel 6...
FATAL: Failed to set SSID 95:Operation not supported


but as you can see it does not start :/

maybe an other idea ?

Thx a lot for your help...



-------------
> Yup - do *not* do "ifconfig ethX up" before starting kismet. If it
 is
> up, do "ifconfig ethX down" and then start it. Kismet won't start if
> Linux has the interface 'Up'.
> 
> 
> Cheers
> Simon
> 
> +++
> OK
> ATH
> NO CARRIER
> _
> 
> 
> 
> > -----Original Message-----
> > From: prism54-users-admin@prism54.org 
> > [mailto:prism54-users-admin@prism54.org] On Behalf Of 
> > Buffenoir Mathieu
> > Sent: Thursday, 12 February 2004 1:50 a.m.
> > To: prism54-users@prism54.org
> > Subject: [Prism54-users] (no subject)
> > 
> > 
> > 
> > Hello,
> > 
> > I tryed to start kismet Feb.04.01 with my WG511 card 
> > (netgear) and got  this error message: "Failed to set SSID 
> > 95:Operation ot supported"
> > 
> > can someone help me to correct this ?
> > 
> > Thx ;)
> > 
> > Tium
> > 
> > _______________________________________________