[Prism54-users] Mode tests

[gipmanr@mtn.co.ug]

[root@gipu-remote root]# iwconfig=20
lo        no wireless extensions.

eth0      no wireless extensions.

eth1      PRISM Duette  ESSID:"Dogo1" =20
          Mode:Ad-Hoc  Frequency=3D2.462GHz  Cell: 6E:9D:B6:2D:74:A4 =20
          Bit Rate:54Mb/s   Sensitivity=3D20/200 =20
          Retry min limit:8   RTS thr:2347 B   Fragment thr:2346 B  =20
          Encryption key:686F-6265-73   Security mode:restricted
          Link Quality:1  Signal level:0  Noise level:255
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

Say's it all don't it

-----Original Message-----
From: Claas Hilbrecht
[mailto:claas+maillinglists.prism54-users@jucs-kramkiste.de]=20
Sent: Wednesday, December 17, 2003 5:27 PM
To: prism54-users@prism54.org
Subject: Re: [Prism54-users] Mode tests

> Is there a way to find out which ethX devices is handled by the =
prism54
> driver? The hostap driver lists all devices in /proc/net/hostap/*. Is
> there anything similar for the prism54 driver?

To be more precise. A simple iwconfig 2>/dev/null and some =
grepping/seding=20
is not sufficent since it is possible that there is more than one =
wireless=20
lan card installed. And the other card is maybe not a prism54 based =
card. I=20
need this information to set ACL one the wlan cards and the other wlan=20
cards uses different iwpriv calls to set ACL and MAC addresses.

---
 Claas Hilbrecht
 http://www.jucs-kramkiste.de

_______________________________________________
Prism54-users mailing list
Prism54-users@prism54.org
http://prism54.org/mailman/listinfo/prism54-users