[Prism54-devel] [Bug 90] New: Bulk timeout on usb after loading firmware

[Rob Hill]

I'm also getting exactly this error, and I have the same setup, although
with an EPIA M10000, and a D-Link DWL-G120.

Regards

Rob



On Sat, 2004-06-19 at 09:04, bugzilla-daemon at mcgrof.com wrote:
> http://localhost/cgi-bin/bugzilla/show_bug.cgi?id=90
> 
>            Summary: Bulk timeout on usb after loading firmware
>            Product: prim54
>            Version: 1.2
>           Platform: PC
>         OS/Version: Linux
>             Status: NEW
>           Severity: blocker
>           Priority: P2
>          Component: Device Driver
>         AssignedTo: prism54-devel at prism54.org
>         ReportedBy: centraladmin at lahiette.com
> 
> 
> With the following config : 
>  - prism54_usb (latest CVS tarball)
>  - kernel 2.6.6
>  - EPIA 800 (chipset VIA)
>  - Linksys WUSB54G (prismGT based)
> I can do a modprobe prism54u, the module is properly loaded and it creates an 
> eth1 interface.
> Then i do a ifconfig eth1 up, the firmware loads and i get always the message :
> usb 1-2 : Bulk timeout on ep2out
> Morover, if i do a ifconfig -a , i can see the eth1 interface, but with a wrong 
> (illegal in fact!) MAC address.
> 
> 1 - Is there any way to set some options in the prism54_usb C code to try to 
> find a workaround ?
> 2 - Is there any additionnal options to set when loading the module ?
> 3 - Is there anu additionnal options to set with the ifconfig command ?
> 2 - Either do you have any idea of this problem ?
> 
> 
> 
> ------- You are receiving this mail because: -------
> You are the assignee for the bug, or are watching the assignee.
> _______________________________________________
> Prism54-devel mailing list
> Prism54-devel at prism54.org
> http://prism54.org/mailman/listinfo/prism54-devel
-- 
+-----------------------------+
  Rob Hill                   
  Systems Manager
  Dot Communications
  Tel: (02) 9281 1111 Ext.101
+-----------------------------+