[Prism54-devel] OID_ATTACHMENT

[Rafiq Shaikh]

Hi,

I am tyring to attach additional information element to Beacon type 
messages. I have enabled MLME extended before setting the attachment.
The SET operation for OID_ATTACHMENT is successfull. However the 
firmware gives interrupt 0x4000 (boot Rom) when it is trying to send out 
very first Beacon frame.

I tried to use different message type to attach the new element to (eg 
Authentication, Association Response, Probe Response) but still I see 
the same problem.

Can somebody put light on this.
What all the driver is expected to do so that the attached new element 
shows up in the out going messsages?

Regards,
-Rafiq.